AMP-220 Amplifier for 1.25M (220-225MHz), 30-50W Output (2-6W Input), Analog and Digital Modes, Compatible with All Handheld Radios: , BaoFeng, Kenwood, Yaesu, ICOM, Motorola

Style: AMP-220
Analog | Size: 1.25M (220-225MHz)Technical
Details: Frequency
range:
AMP-220: 220 225 MHz
Power supply: 13.8 VDC (15%), 5.5 A maximum
Input RF power: 2 - 6W (10%)
Output RF power: 30 - 50W
Size: 5.5 -in D x 4.5 -in. W x 1.4 -in.
H (40 mm D x 115 mm W x 36 mm H) Net weight: 1.8 lbs. (800 g) The AMP-25 Series is designed to work with any BaoFeng or handheld transceivers, but it will also work with any handheld radio that outputs 2 W 6 W with the appropriate cable. With the included Radio to Amplifier RF Cable, the amplifier will also work with Wouxun transceivers, some TYT transceivers, and some Kenwood transceivers. If the supplied cables do not connect to your radio, you will need to use adaptors or build cables with the appropriate connectors. Your AMP-25 amplifier does not include an antenna. It is very important to not transmit without an antenna or dummy load connected to the ANT connector on the rear panel of the amplifier. Transmitting without an antenna or dummy load may cause harm to the radio equipment. When choosing an antenna, make sure that it is suitable for the bands you plan on transmitting and receiving on. For example, if you plan on transmitting on 145MHz, make sure that the antenna you select has an
SWR of 1.5: 1 or less on that frequency. Using an antenna with an
SWR greater than 1.5: 1 could damage the amplifier. If you plan to use a magnetically-mounted (mag-mount) antennas, ensure that the antenna is grounded to a metal surface, such as a vehicle body. Magnetically-mounted antennas do not operate properly without a good ground.