Tycon Wireless Outdoor Point to Point Bridge EZBR-0214+ with Two 2.4GHz 14dBi MIMO Antennas and Two PoE Power inserters

Tycon Wireless Outdoor Point to Point Bridge EZBR-0214+ with Two 2.4GH z 14dBi MIMO Antennas and Two PoE Power inserters


Item Condition: New

Brand: tycon power systems
Item model number: EZBR-0214+

Product Information

- The EZ-Bridge-LT+ is a high power outdoor 250mW wireless bridge system operating in the 2.4GH z unlicensed frequency spectrum providing real world thruput up to 100 Mb/sec
- It complies with the 802.11 g and n standards to insure interoperability
- The EZ-Bridge-LT+ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight
- It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access
- Multiple EZ-Bridge-LT+ units can be connected in a mesh configuration to allow interconnecting more than two sites

The EZ-Bridge-LT+ is a high power outdoor 250mW wireless bridge system operating in the 2.4GH z unlicensed frequency spectrum providing real world thruput up to 100 Mb/sec. It complies with the 802.11 g and n standards to insure interoperability. The EZ-Bridge-LT+ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge-LT+ units can be connected in a mesh configuration to allow interconnecting more than two sites. The EZ-Bridge LT+ comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 14dBi 802.11 gn MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Cat5e rated POE (Power Over Ethernet) power inserters and 24VDC auto-ranging power supplies. Power over
Ethernet: Antennas can be mounted up to 100meter (300’) from the power inserter. No driver needed. Pre-configured at the factory for automatic peer to peer communications. Customer needs to supply CAT5 cabling between the power inserter and the antenna and between the power inserter and his computer, router or switch.