PP500 Ultra-Compact Phono Preamp Preamplifier with Level & Volume Controls RCA Input & Output 1/4 Inch TRS Output Interfaces

Size: PP500Instructions (1) 12
V connector: To connect the power supply unit to the PP500, use the 12 V connector. Connecting the power supply unit to the mains automatically switches the PP500 on. To disconnect the unit from the mains, pull out the main cord plug.
(2) ON LED: As soon as the unit is connected to the mains, the ON LED is illuminated.
(3) INPUT (L and R) connectors: To send a turntable signal to the PP500, you need an RCA audio cable (stereo).
Use this cable to connect: the left output on the turntable to the L (left) INPUT on the PP500 the right output on the turntable to the R (right) INPUT on the PP500 The PP500 can output a line-level signal via one of the following connectors: RCA ( (4) OUTPUT L and R) TRS ( (5) OUTPUT) Do not simultaneously use both PP500 OUTPUTS.
(4) OUTPUT (L and R) connectors: To use these RCA connectors, you need an RCA audio cable (stereo). Use this audio cable to connect: the L (left) OUTPUT on the PP500 to the left input on the amplifier, recording unit, or mixer. (On a mixer, use a CD or TAPE input. ) the R (right) OUTPUT on the PP500 to the right input on the amplifier, recording unit, or mixer (5)
OUTPUT connector: To use this, TRS (stereo) connector, you need an audio cable. Use the audio cable to connect the PP500 OUTPUT to an input on the mixer, amplifer, or recording unit. One end of this audio cable must include a, TRS connector. If the input on the mixer, amplifier, or
recording unit is: stereo, the other end of the audio cable must include a, TRS connector mono, the other end of the audio cable must include 2 TS connectors (one for each mono input)