Buy Say Yeah Products online in United States

RCA Video Cable CAZBC13 CAR Reverse Rear View…

$ 25.09 $ 25.34

Telescope with Smartphone Holder - 12X50 High Power…

$ 27.00 $ 27.83

Size: 1 Handset | Style: Fixed | Pattern Name: Phone Troubleshooting ~ "won't charge". Tip 1 Ensure that the cords (power and telephone line) are plugged into the channels on the bottom of the base/charger. If the cords are not properly installed, the base may not sit level. This can cause the phone not to make contact with the base and the handset will not charge. Ensure that your cordless handset is cradled properly. When placing the handset in the charging base, confirm that the charge contacts on the handset and base are making a good connection. The CHARGE light on the telephone handset will be on when the handset is charging. Tip 2 For mulit handset systems: To determine if the handset or charger is defective, place the handset in another charger or base. If the charge light comes on, replace the defective charger. If the base is defective, replace the whole unit. For single handset systems or when all HS's are affected follow the steps below: If the handset is not responding normally, you may need to reset your telephone system. Complete the following steps to reset the telephone system: Step 1: Disconnect the power to the telephone base. Step 2: Disconnect the handset battery (s). Step 3: Wait a few minutes and then reconnect the power to the telephone base. Step 4: Reconnect the handset battery (s). Step 5: Wait about one minute for the handset to re-establish a link with the telephone base and then test the phone again. NOTE: After resetting the telephone system, you will need to reset the clock: Step 1 When the phone is not in use, press MENU/SELECT. Step 2 Press DIR or CID until you see >SET DATE/TIME. Step 3 Press MENU/SELECT. Use the dialing keys to set the month date and year. Step 4 Press MENU/SELECT. Use the dialing keys to set the hour and minute; then press DIR or CID to select AM or PM. Step 5 Press MENU/SELECT to confirm your settings. Press and hold OFF/CANCEL to return to the idle screen. Tip 3 Dirty charge contacts on the telephone base and handset could prevent the batteries from charging. Clean the handset and base charge contacts using a pencil eraser or a cloth to eliminate deposit accumulation. Tip 4 Confirm proper installation of the telephone base power supply and handset battery. You should only use the power supply provided with your telephone. Make sure the power supply is not connected to an electrical outlet that is controlled by a wall switch. Confirm that the electrical outlet that the telephone is plugged into is working. Tip 5 Ensure that the battery cover is installed correctly. When correctly installed, the batttery cover should be flush with the handset. If there are any spaces or gaps around the battery cover, the unit may not charge properly. Tip 6 If the battery is less than 1 year old and talk time is less than 3 hours, replace the battery. If the battery is more than 1 year old and there is an issue with the battery, customer may need to purchase a new battery.

EL52100 DECT 60 Cordless Phone with Digital Answering…

$ 76.88 $ 77.66

Color: Black | Style: Body Only | Configuration: Base X-E2 Body 16.3 MP APS-C X-Trans II CMOS Sensor with Phase Detection and EXR Processor II. From the Manufacturer X-Trans* CMOS II & EXR Processor II, harnessing the full potential of each lens to capture breathtaking quality in every image. World's fastest auto focus speed of 0.08 sec. ** achieved by 's unique phase detection AF system. The design of prioritizes "photographing" enabling instinctive operation and high-speed responses. X Mount Lens - the product of integrated lens & sensor development with original digital technology. X-E2 Evolution: Impact on Shooting & Playback Functions. Sensor: APS-C "X-Trans CMOS II" Effective Pixels: 16M LCD Monitor: 3.0 -inch (1, 040K-dot) Sensitivity: ISO 25600 Even faster so the moment cannot escape. World's fastest AF speed of 0.08 sec. ** achieved via the integration of phase detection pixels into the advanced sensor. High-speed responses from the on-sensor phase detection AF system. Accurate focusing in dark scenes that only contrast AF can deliver. The X-E2 has both, plus Intelligent. Hybrid AF for automatic switching to the optimal focusing system for the scene and conditions. A newly developed algorithm improves AF accuracy when shooting low- contrast subjects and dark scenes. The evolved AF system of the X-E2 brings your subject into sharp focus so quickly that priceless moments will never escape your lens. Even more beautiful color reproduction and even higher definition image capture. The ultimate sensor, APS-C 16M X-Trans CMOS II. X-Trans CMOS II for unmatched color reproduction. 's unique X-Trans CMOS II array eliminates the need for an OLPF, enabling the sensor to capture unfiltered light from the lens for an precedented level of resolution. Lens Modulation Optimizer technology brings out the full potential of the XF lens. The advanced Lens Modulation Optimizer (LMO) technology in the X-E2 was made possible by the integrated development of the lens, sensor and processor. For each mounted lens, LMO high-precision processing of the lens focal length and aperture, as well as data from the screen center to the edges, corrects diffraction blur when shooting with a stopped down aperture and compensates for the slight blurring in the lens periphery. The result is edge-to-edge image quality with incredible sharpness and a sense of dimensional reality. * Lens firmware update required. X-Trans CMOS II Sensor Capture each strand of hair in crisp detail. Due to the X-Trans CMOS II sensor architecture that eliminates the need for an optical low-pass filter (OLPF) and integrates FUJFILM's originally developed color filter array, the X-E2 reproduces scenes with resolution and clarity rivaling a larger sensor. Conventional Array Repeating pattern in the case of an array of 2 x 2 pixel units. New Filter Array Higher degree of randomness with an array of 6 x 6 pixel units. X-Trans CMOS II sensor incorporates an original color filter array with a highly random pattern, eliminating the need for an optical low-pass filter (OLPF). These filters are used in conventional systems to inhibit moiré at the expense of resolution. The X-Trans CMOS II sensor array lets the sensor capture unfiltered light from the lens, achieving an unprecedented level of resolution. Intelligent Hybrid Auto Focus World's fastest AF speed of 0.08 sec. * achieved via the integration of phase detection pixels into the advanced sensor. High-speed responses from the on-sensor phase detection AF system. Accurate focusing in dark scenes that only contrast AF can deliver. The X-E2 has both, plus Intelligent Hybrid AF for automatic switching to the optimal focusing system for the scene and conditions. A newly developed algorithm improves AF accuracy when shooting low-contrast subjects and dark scenes. The evolved AF system of the X-E2 brings your subject into sharp focus so quickly that priceless moments will never escape your lens. Manual Focusing Digital Split Image**, the worl

X-E2 16.3 MP Mirrorless Digital Camera with 3.0-Inch…

$ 2,737.69 $ 2,793.56

Basics Collapsible Fabric Storage Cubes Organizer with Handles,…

$ 49.09 $ 50.61

T7 Vacumn Tube Mini Phono Stage RIAA MM…

$ 202.76 $ 206.90

Digital Coaxial Toslink Adapter with Optical Cable 35mm…

$ 43.24 $ 44.12

Silicone Watch Band Replacement for SparkSpark 3Golfer 2AdventurerRunner…

$ 50.91 $ 51.42

Voice 2 Golf GPS/Rangefinder Bundle with Ball Marker…

$ 236.85 $ 241.68

CFO11SD100 11-Inch Olive Green Nylon Standard Duty Cable…

$ 26.63 $ 27.17

1600HC 35 Inch VHF Marine Antenna

$ 118.06 $ 119.25

Product Packaging: Standard PackagingCompatible Battery (Not Included): AA Ni-MH or Alkaline battery; Panasonic SD Series Li-ion Batteries; Sony Li-ion Battery FH, FM and F models. NOTE: Sony FW series battery can not work with the LED panel. The CN-160 can mount to any standard hot shoe on most DSLR or digital video cameras as well as tripods and light stands equipped with a hot shoe mount or 1/4" thread. It is also equipped with a pivoting head, allowing you to raise or lower the light's angle. The light is battery powered and requires 6x AA Lithium Ion batteries (not included). With the included battery adapter, you can substitute the AA batteries for Sony NP-FH NP-FM NP-F Series, or Panasonic CGR-D16S rechargeable batteries. Battery life can easily be monitored using the battery power indicator located under the battery compartment. The CN-160 LED Video Light is easy to install and use and will make a great addition to your photography or video studio. Features: The LED camcorder lamp light allows you to link lights together to make larger light. Features 160-LED lights for optimum illumination and diffuser. Helps to ensure your pictures's perfect settings. This super lightweight 160-piece-LED item can be used in video taking, either for lights setup or supplement. There are 2 filters included with this item, with Spotlight effect, Diffuse effect, and for reducing the color temperature to 3200K. The light intensity can be changed to offer professional effects. Designed with Standard hot shoe plug, so can be installed on the DV or DSLR, and DC with standard hot shoe. Rotate switch for on/off and brightness adjustment. Adopts concentration LED lights, irradiation distance can reach more than 5m, suitable for long distance shooting. the light can also be adjusted from concentrating light to diffusing light which is suitable for short distance shooting. Compatible batteries (not included): Sony NP-FH NP-FM NP-F Series Li-ion rechargeable battery Panasonic CGR-D16S rechargeable battery Alkaline/NiMH AA Battery Suitable for: Can be installed on many Cameras like Canon, Nikon, Sigma Olympus, Pentax, etc. Specifications: Maximum Power: 9.6 Watt Material of the Lighting's Shell: ABS Plastic Color Temperature: 5600K (3200k w/filter) Luminous flux: 660 lm Video light size: 141mm x 62mm x 150mm Runtime: 60-80mins Illumination: 900Lux (1m), 240Lux (2m), 120Lux (3m), 70Lux (4m), 40Lux (5m) Effective distance: 6m/20ft Size: 141x62x150 mm Weight: 8.57 oz