Buy Ortofon Products online in United States

Ortofon VNL Introduction Package

$ 208.06 $ 214.49

Ortofon Concorde Mix Replacement Stylus

$ 119.80 $ 122.25

Ortofon Concorde Scratch MKll Twin

$ 855.13 $ 881.58

ortofon: made from scratch replacement stylus

$ 120.87 $ 124.61

ortofon stylus 78 replacement stylus

$ 193.43 $ 199.41

ortofon pro s replacement stylus

$ 99.28 $ 101.31

Ortofon Stylus 5E Replacement Stylus

$ 95.76 $ 100.80

Ortofon Concorde Club MKII Replacement Stylus

$ 142.26 $ 143.70

Ortofon OM-5E Single Turntable Cartridge

$ 147.14 $ 150.14

Ortofon Concorde DIGITAL MKII Cartridge (Single)

$ 461.89 $ 476.18

Ortofon Stylus 10 Single Replacement Stylus

$ 130.33 $ 132.99

Ortofon Scratch White Single Replacement Stylus

$ 101.92 $ 102.95

Ortofon Concorde SCRATCH MKII Cartridge (Twin)

$ 870.65 $ 879.44

Ortofon Concorde CLUB MKII Cartridge (Single)

$ 530.57 $ 546.98

Ortofon Q.Bert Single Replacement Stylus

$ 123.16 $ 124.40

& lt;font color= & quot;#FF0000 & quot; & gt; & lt;b & gt;HiFi System & amp; Cartridge Test LP! & lt;/b & gt; & lt;/font & gt; & lt;br & gt; & lt;br & gt; & lt;b & gt;This item not eligible for any further discount offers! & lt;/b & gt; & lt;br & gt; & lt;br & gt; Ortofons new Test Record is designed to allow you to verify your HiFi system in the most natural audio surroundings at home. The Test Record contains special test signals developed for analyzing cartridge performance as well as its interaction with your tonearm and turntable. & lt;br & gt; & lt;br & gt; Before testing your cartridge, please verify the HiFi systems functionality. The left speaker should be connected to the left amplifier channel and vice versa; both speakers should work in phase and be optimally positioned in the room. & lt;br & gt; & lt;br & gt; The Test Record is designed to be played through your system with in-built RIAA equalization. Volume control is recommended to be set at a moderate signal level. & lt;br & gt; & lt;br & gt; Please refer to your turntable and tonearms instructions for correct installation and alignment, adjust tonearm to be parallel to record surface, set Vertical Tracking Force and antiskating according to the cartridges recommended technical data, and adjust stylus overhang. & lt;br & gt; & lt;br & gt; & lt;b & gt;1-4 Frequency sweep & lt;/b & gt; a tool for checking frequency response & lt;br & gt; There are several factors which can affect frequency response, including cable capacitance, cartridge loading, tracking force and worn parts. Because of this, it can be difficult to achieve perfectly flat frequency response. Sometimes by making small compromises in the cartridge loading, a better overall frequency response can be achieved. Considering the above the signal must be clean throughout the sweep. & lt;br & gt; & lt;br & gt; & lt;b & gt;5-8 Reference tone for testing channel output & lt;/b & gt; & lt;br & gt; With this standard reference signal is it possible to check the correctness of the connections of the left and right channels, channel balance and speed of the turntable. & lt;br & gt; & lt;br & gt; & lt;b & gt;9-14 Tracking ability test, 315 Hz lateral modulation & lt;/b & gt; & lt;br & gt; These tracks contain a 315 Hz signal, recorded at increasing pick amplitudes of 50, 60, 70, 80, 90 and 100 micrometers. Please refer to your cartridges tracking ability value specified in the technical data sheet. Your cartridge should be able to track the actual level without audible distortion. Inability to track can be heard as a departure from a pure tone or a sputtering and intermittent tone. To determine if it is one or both channels, the balance control can be utilized. In case of differing tracking ability in the left and right channels it is probably necessary to readjust the anti-skating correction of the tonearm. If both channels fail to track properly, then vertical tracking force should be increased until no further improvement of tracking force can be obtained. & lt;br & gt; & lt;br & gt; & lt;b & gt;15. Square Wave Form 2.7 msec duty cycle 3:7 & lt;/b & gt; & lt;br & gt; When monitoring the output of your cartridge with an oscilloscope youll then see a square wave located precisely above each other if the connection from the cartridge is correct. & lt;br & gt; & lt;br & gt; After successful completion of the above test procedures, you can ensure that your cartridge is optimized. Still the human ear is very sensitive to difference in tone distortion; its level depends on the stylus condition and record wear. & lt;br & gt; & lt;br & gt; To maintain optimal sound reproduction and to minimize wear on your records as well as on your stylus, Ortofon recommends the following procedure before and after each playback: & lt;br & gt; Remove dust carefully from record surfaces by using a fine antistatic brush or cloth before every use. & lt;br & gt; Please remember to remove dust from the diamond tip before and after playback of each record & lt;br & gt; In order to keep electrical contacts clean and to lubricate the knurled nut on the tonearm, Ortofon recommends occasionally a light spray of contact cleaner like DeoxIT ®Gold G-Series into the tonearm socket. & lt;br & gt; & lt;br & gt; It should be noted that some phono equalizers may generate some tone distortion, which cannot be referred to the cartridge. & lt;br & gt; & lt;br & gt; & lt;b & gt;The Tests: & lt;/b & gt; & lt;br & gt; Each side of the record consists of 15 tracks which have been cut from 1-4 and 5-15: & lt;br & gt; 1. Frequency Sweep Left Channel 800 Hz 50 kHz. 28 sec. (800 20000 Hz ±1,5 dB) & lt;br & gt; 2. Frequency Sweep Right Channel 800 Hz 50 kHz. 28 sec. (800 20000 Hz ±1,5 dB) & lt;br & gt; 3. Frequency Sweep Left Channel 800 Hz 50 kHz. 28 sec. (800 20000 Hz ±1,5 dB) & lt;br & gt; 4. Frequency Sweep Right Channel 800 Hz 50 kHz. 28 sec. (800 20000 Hz ±1,5 dB) & lt;br & gt; 5. Reference tone 1000 Hz 5 cm/sec rms Left & lt;br & gt; 6. Reference tone 1000 Hz 5 cm/sec rms Right & lt;br & gt; 7. Reference tone 1000 Hz 5 cm/sec rms Left & lt;br & gt; 8. Reference tone 1000 Hz 5 cm/sec rms Right & lt;br & gt; 9. Tracking ability, lateral 50 µm peak & lt;br & gt; 10. Tracking ability, lateral 60 µm peak & lt;br & gt; 11. Tracking ability, lateral 70 µm peak & lt;br & gt; 12. Tracking ability, lateral 80 µm peak & lt;br & gt; 13. Tracking ability, lateral 90 µm peak & lt;br & gt; 14. Tracking ability, lateral 100 µm peak & lt;br & gt; 15. Square Wave duty Cycle 3:7 & lt;br & gt; * The record has a constant velocity amplitude throughout the sweep. & lt;br & gt; & lt;br & gt; & lt;b & gt;Corrective Note: & lt;/b & gt; & lt;br & gt; For information about Tracks please refer to the User manual and Ortofon web: each side of the record consists of 15 tracks which have been cut from 1-4 and 5-15.